39
4 After adjusting folding slippage,
continue pressing the “fixed folding
correction” button until the buzzer
(pi, pi, pi) sounds.
• When the value of the folding stopper correction is
registered, the display lamp of the specified
folding mode will start blinking.
Once the value of the folding stopper
correction is registered, it will be kept even
after the power is turned off.
8. FOLDING ADJUSTMENTS AND REGISTERING CORRECTIONS
To change the correction
value
• Carry out the procedure for registering corrections.
To erase the registration • Continue pressing the “fixed folding correction”
button until the buzzer sounds pi, pi, pi and changes
to pi.... (takes about 5 seconds).
• When the registration is erased, the fixed folding
display lamp stops blinking.
To Next Page
Loading...
Need help?
General