Duplo DF-920 User Manual

40
13. CROSS FOLDING
Close the top cover.
8
Weight roller
Length of
single-folded paper
Paper feed direction
Place the weight roller of the cross
folding guide on the folded line.
9
To replenish paper, lift the cross folding
guide.
NoteNote
Set the folding mode to single folding,
perform test folding, and check the
finish.
10
Other steps are the same as standard folding
of standard paper.
“9. STANDARD FOLDING OF STANDARD
PAPER” (
☞
p.22)
SeeSee
13-4. Cross Folding of
Non-standard Paper
Single fold non-standard paper
according to the procedure of “11.
STANDARD FOLDING OF NON-
STANDARD PAPER” (
☞
p.32).
1
Press the No. of sheets/Paper length
key and switch to the mode for entering
paper length.
2
Measure the length of the single-folded
paper, and enter the length using the
numerical keys.
3
Press the No. of sheets/Paper length
key until the buzzer sounds “pi.pi...”
(about two seconds), to register the
paper length.
4
Perform steps 2 to 10 of “13-3. Cross
Folding of Standard Paper” (
☞
p.39).
5
Other steps are the same as standard folding
of standard paper.
“9. STANDARD FOLDING OF STANDARD
PAPER” (
☞
p.22)
SeeSee
13-5. Cross Folding Paper at
the Desired Folding Position
After registering custom folding
according to the procedure of “12.
CUSTOM FOLDING” (
☞
p.35), single
fold paper in the custom folding mode.
1
Register the single-folded paper for
custom folding at the desired folding
position according to the procedure of
“12. CUSTOM FOLDING” (
☞
p.35)
again.
2
Perform steps 2 to 10 of “13-3. Cross
Folding of Standard Paper” (
☞
p.39).
3
Set the folding plate 1 folding stopper
position as desired when registering
custom folding. Set the folding plate 2
folding stopper position to 0" as folding
plate 2 is not used in single folding.
NoteNote
Other steps are the same as standard folding
of standard paper.
“9. STANDARD FOLDING OF STANDARD
PAPER” (
☞
p.22)
SeeSee

Duplo DF-920 Specifications

General

Brand	Duplo
Model	DF-920
Category	Folding Machines
Language	English