15
Press
(END)
it will beep 4 times, then re-press
(END)
to store the program, and the
screen will change to:
If you want to start cutting, press
(AUTO),
the backgauge will move to the 14.0”
position and the following screen appears:
After finishing the first cut, the backgauge will move in forward 2.0” and the following
screen appears:
After you have made 7 consecutive cuts, the backgauge will automatically “push-out”
your stack of paper and moves to the first cut position at 14.0”, then you can start the
second cutting cycle:
After you have finished all cuts, press
(AUTO)
to remove the automatic backgauge
movement, AUTO will disappear on the display, and this screen appears:
NOTE: If you make a mistake and want to correct the programmed cut positions,
use the (LAST) and (NEXT) keys to move the cursor to the position that you
require, and re-enter new cut sizes, then press (NEXT).
C: 26”125 PROG: 3
1: 14”00
❑
2:
−
02”000
C: 14”000 PROG: 3 AUTO
1: 14”00
❑
2:
−
02”000
C: 12”000 PROG: 3 AUTO
3:
×
0 7 4: 00”000
C: 14”000 PROG: 3 AUTO
1: 14”00
❑
2:
−
02”000
C: 14”000 PROG: 3
1: 14”00
❑
2:
−
02”000
To Next Page
Loading...
