Duplo Programatic Mark - II - How to Use Step and Repeat Program with a Gutter Trim

16
How to use Step and Repeat Program with a Gutter Trim:
Turn on the power to the cutter, wait until the backgauge moves back and will
recalibrate the position and this display appears:
NOTE:
There will be a cursor (
❑
) flashing over at the last number, this is the work area.
Select a program number from 1-9, if you press
(PROG)+(4)
this screen appears:
If the first cut were at 8.75” and you would like to divide it into 2.0” name cards with a
0.25” trim in between for 4 times each, please do as follows:
Press
(8)+(7)+(5)+(0)
and
(NEXT)
, the following screen appears:
Press
(
−
)+(2)+(0)+(0)+(0)
and
(NEXT)
and this screen appears:
Press
(
−
−
)+(2)+(5)+(0)
and
(NEXT)
and this screen appears:
Press
(
×
)+(3)
and
(NEXT)
the following screen appears:
C: 26”125 PROG: 1
1: 00”00
❑
2: 00”000
C: 26”125 PROG: 4
1: 00”00
❑
2: 00”000
C: 26”125 PROG: 4
1: 08”750 2: 00”00
❑
C: 26”125 PROG: 4
3: 00”00
❑
4: 00”000
C: 26”125 PROG: 4
3:
−
02”500 4: 00”00
❑
C: 26”125 PROG: 4
5: 00”00
❑
6: 00”000