Duplo Programatic Mark - II - How to Use Step and Repeat Program

14
How to use Step and Repeat Program:
Turn on the power to the cutter, wait until the backgauge moves back and will
recalibrate the position and this display appears:
NOTE:
There will be a cursor (
❑
) flashing over at the last number, this is the work area.
Select a program number from 1-9, if you press
(PROG)+(3)
screen appears:
If the first cut will be at 14.0” and you would like to divide it into 2.0” labels x 7, please
do the following:
Press
(1)+(4)+(0)+(0)+(0)
and
(NEXT),
the following screen appears:
Press
(
−
)+(2)+(0)+(0)+(0)
and
(NEXT)
and this screen appears:
Press
(
×
) (6)
and
(NEXT)
and the screen will change to:
C: 26”125 PROG: 1
1: 00”00
❑
2: 00”000
C: 26”125 PROG: 3
1: 00”00
❑
2: 00”000
C: 26”125 PROG: 3
1: 14”000 2: 00”00
❑
C: 26”125 PROG: 3
3: 00”00
❑
4: 00”000
C: 26”125 PROG: 3
3:
×
06 4: 00”00
❑