This manual describes the App commissioning process of the following models of Power Center
D350-M1 / D700-M2 / D1500-M4
This manual is only for qualied technicians/account administrators, who have been trained or
have demonstrated skills to install and maintain/monitor this microinverter under the guide of
this document for safety purposes.
2.1 Important Safety Instructions
Mobile App Commissioning Manual
All operations including transport, installation, start-up, and maintenance, must be carried out by qualied trained
personnel.
Before installation, check the unit to ensure free of any transport or handling damage, which could aect insulation
integrity or safety clearances. Choose the installation location carefully and adhere to specied cooling
requirements. Unauthorized removal of necessary protections, improper use, incorrect installation and operation
may lead to serious safety and shock hazards or equipment damage.
Before connecting a microinverter to the power distribution grid, contact the local power distribution grid company
to get appropriate approvals. This connection must be made only by qualied technical personnel. It is the
responsibility of the installer to provide external disconnect switches and Over current Protection Devices (OCPD).
Only one photovoltaic module can be connected to one input of the inverter. Do not connect batteries or other
sources of power supply. The inverter can be used only if all the technical characteristics are observed and applied.
Do not install the equipment in adverse environment conditions such as ammable, explosive, corrosive, extreme
high or low temperature, and humidity. Do not use the equipment when the safety devices do not work or disabled.
Use personal protective equipment, including gloves and eye protection during the installation.
Inform the manufacturer about non-standard installation conditions.
Do not use the equipment if any operating anomalies are found. Avoid temporary repairs.
All repairs should be carried out using only qualied spare parts, which must be installed in accordance with their
intended use and by a licensed contractor or authorized Power Center service representative.
Liabilities arising from commercial components are delegated to their respective manufacturers.
Anytime the inverter has been disconnected from the public network, please be extremely cautious as some
components can retain charge sucient to create a shock hazard. Prior to touching any part of the inverter please
ensure surfaces and equipment are under touch safe temperatures and voltage potentials before proceeding.
Power Center accepts no liability for damage from incorrect or improper operation.
Electrical Installation & Maintenance shall be conducted by a licensed electrician and shall comply with Local Wiring
Rules.
The microinverters are designed and tested according to the international safety requirements.
However, certain safety precautions must be taken during installation and operation. The
installer must read and follow all instructions, cautions, and warnings in this installation
To Next Page
Loading...
