2.2 Explanation of Symbols
Mobile App Commissioning Manual
Mobile App Commissioning Manual
Treatment
To Comply with the European Directive 2002/96/EC on waste Electrical and Electronic Equipment and its
implementation as national law, electrical equipment that has reached the end of its life must be collected separately
and returned to an approved recycling facility. Any device no longer required must be returned to an authorized dealer
or approved collection and recycling facility.
Caution
Indicated directions which must be fully understood and followed in entirety in order to avoid personal safety hazards
including equipment damage or personal injury.
Danger of High Voltages
Indicates a hazardous situation that can result in deadly electric shock hazards, other serious physical injury, or re
hazards.
Indicates that the reader should stop, use caution and fully understand the operations explained before proceeding.
Beware of hot surface
The inverter can become hot during operation. Avoid contact with metal surfaces during operation.
FCC Mark
The inverter compiles with the requirements of part 15 of FCC rules
2.3 Radio Interference Statement
This microinverter has been tested and found to comply with the limits for part 15 of FCC
rules, which can provide reasonable protection against harmful energy. However, if not
installed according to the instructions, the microinverter may cause harmful interference to
radio equipment. There is no guarantee that the interference will not occur in a particular
To conrm that the radio or television reception is interfered by this equipment, you can turn
the equipment o and on. If this equipment does cause harmful interference to the radio or
television equipment, please try to correct the interference by one or more of the following
measures:
1 Relocate the receiving antenna
2 Increase the separation between the microinverter and the receiving antenna
3 Contact your dealer or an experienced radio/TC technician for help
To Next Page
Loading...
