8 | 4.2 Using a USB Cable
DuraLabel.com | 800.788.5572
ConneCting the printer
4.2 Using a USB Cable
IMPORTANT! You may need IT administrator privileges to perform this installation.
If a Found New Hardware announcement appears, select No, not at this time.
A. Insert the DuraLabel PRO or DuraLabel PRO 300 Installation CD in your computer’s
disk drive. A DuraLabel PRO/PRO 300 startup screen appears.
NOTE: If the CD does not run automatically, go to Start > Computer and double-click on
your CD/DVD drive, which should show the DL icon.
B. Click on Driver Wizard, then click Next in the Driver Wizard setup window that
appears.
C. Click I Agree on the Windows Printer Driver License Agreement window that
appears.
D. Select DuraLabel PRO or DuraLabel PRO 300 and click Next on the DuraLabel
Driver Setup window that appears.
E. Choose the install location and click Install on the Choose Install Location window
that appears.
F. Select Install printer drivers on the Driver Wizard window that appears and click
Next.
G. A Plug and Play Detection window appears
*
. Highlight Graphic Products DuraLabel
PRO or DuraLabel PRO 300 and click Next.
*
NOTE: Windows 8 users, check Install a driver for another printer, continue to the next
screen and select Graphic Products DuraLabel Pro or DuraLabel Pro 300. At the next
screen choose the appropriate port.
H. Enter Printer Name and set it as the default printer by checking the adjoining box
in the Specify Printer Name window that opens. Choose a sharing option, then click
Next.
I. Review the information on the Completing the Seagull Driver Wizard window
that appears. Click Finish if the information is correct. If it isn’t, correct previous
selections and click Finish when the window’s information is accurate.
To Next Page
Loading...
