10 | 4.3 Using a Parallel Cable
DuraLabel.com | 800.788.5572
ConneCting the printer
J. Review the information on the Completing the Seagull Driver Wizard window
that appears. Click Finish if the information is correct. If it isn’t, revise previous
selections and click Finish when the window’s information is accurate.
K. A Driver Wizard Completed Successfully window appears, confirming the printer
driver installation was completed successfully. Click Close.
L. The previous window closes and a Completing the DuraLabel Driver Setup Wizard
window appears. Click Finish to complete the new driver installation.
To Next Page
Loading...
