R
DURASTAR.COM6
Installation Safety
• Installation must be performed by an authorized dealer or specialist. Defective installation can
cause water leakage, electrical shock, or fire.
• Installation must be performed according to the installation instructions. Improper installation
can cause water leakage, electrical shock, or fire. (In North America, installation must be
performed in accordance with the requirement of NEC and CEC by authorized personnel only.)
• Contact an authorized service provider for repair or maintenance of this unit. This appliance shall
be installed in accordance with national wiring regulations.
• Only use the included accessories, parts, and specified parts for installation. Using non-standard
parts can cause water leakage, electrical shock, fire, and can cause the unit to fail.
• Install the unit in a firm location that can support the unit’s weight. If the chosen location cannot
support the unit’s weight, or the installation is not done properly, the unit may fall and cause
serious injury and damage.
• Install drainage piping according to the instructions in this manual. Improper drainage may
cause water damage to your home and property.
• For units that have an auxiliary electric heater, do not install the unit within three (3) feet of any
combustible materials.
• Do not install the unit in a location that may be exposed to combustible gas leaks. If combustible
gas accumulates around the unit, it may cause fire.
• Do not turn on the power until all work has been completed.
• When moving or relocating the air handler, consult experienced service technicians for
disconnection and re-installation of the unit.
• Excessive Weight Hazard - Use two (2) or more people when moving and installing the unit.
Failure to do so can result in back or other type of injury.
Your air handler is designed to operate in the following indoor and outdoor temperatures. When
your air handler is used outside of the following temperature ranges, certain safety features may
activate and turn off the unit to protect it from damage. We strongly suggest keeping the unit
plugged in at all times when temperatures are below 32°F (0°C) for smooth operation.
TEMPERATURE RANGES
COOL mode HEAT mode DRY mode
Indoor Air
Temperature
60°F - 90°F
(16°C - 32°C)
32°F - 86°F
(0°C - 30°C)
50°F - 90°F
(10°C - 32°C)
Outdoor Air
Temperature
5°F - 122°F
(-15°C - 50°C)
-13°F - 75°F
(-25°C - 24°C)
32°F - 122°F
(0°C - 50°C)
To further optimize the performance of your unit, do the following:
• Keep doors and windows closed.
• Limit energy usage by using TIMER ON and TIMER OFF features.
• Do not block air inlets or outlets.
• Regularly inspect and clean air filters.
OPERATING TEMPERATURES
To Next Page
Loading...