(
General safety instructions
The non-observance
of
the following safety instructions can cause
bo1dily
injuries or damages to
the
machine.
1.
The machine shall
only
be
started
and operated after having read the operating instructions, and
only
by accordingly trained persons.
2. Use the
machine
only
for
the
intended purpose.
3. Do not
operate
the
machine
without the belonging
safety
devices.
4. Switch off main
switch
or pull
out
the mains plug before threading, changing bobbin and change
of
se-
wing tools
(such
as
for
example needle, sewing foot,
throat
plate, feed dog, and, if necessary, knife
and cutting
block),
for
cleaning, maintenance
work
and when leaving
the
workplace.
In
case
of
mechanically
actuated clutch
motors
without
actuation lock, wait until the motor stopped.
5.
General
maintenance
work shall
only
be performed by accordingly trai'ned persons, and in accord-
ance with
the
·
operating
instructions.
6. Repair,
conversion
and maintenance work shall
only
be performed by specialists or accordingly trai-
ned persons.
7. Disconnect
the
machine
from the
vacuum
line in case of maintenance and r
epair
work on the
pneuma-
tic components
of
the machine.
Exceptions
are
adjustment
work
and operation
checkouts
performed by accordingly trained persons.
8.
Work on the electrical components
must
only be
performed
by skilled Blectricians
or
accordingly trai-
ned persons.
9. Work on
live parts and equipment is not allowed.
Exceptions in
compliance
with regulation DIN VDE 0105.
10.
Conversion
or
variations of the machine shall
only
be
performed
in
accordance with all safety regula-
tions.
To Next Page
Loading...
Need help?
General
