To Next PageTo Next Page
Need help?Do you have a question about the DURKOPP ADLER 767 and is the answer not in the manual?
General| Brand | DURKOPP ADLER |
|---|---|
| Model | 767 |
| Category | Sewing Machine |
| Language | English |
Details the usage of setting gauges for precise machine adjustments.
Procedure to adjust the zero position of the stitch regulator link.
Detailed adjustments for the bottom feed mechanism, including feed-dog positioning.
Setting the lateral and feed direction positions of the needle bar wing.
Adjusting the needle's loop formation path relative to the hook.
Setting the vertical position of the needle bar for hook clearance.
Ensuring correct clearance between the hook tip and the needle.
Adjusting the hook guard to prevent needle-hook collisions.
Setting the lateral clearance within the claw clutch mechanism.
Setting the maximum stitch length that can be selected on the machine.
Configuring and operating dual stitch length capabilities on the sewing machine.
Adjusting the timing, size, and lifting course of the bobbin case opening.
Adjusting the stroke and position of the upper feed mechanism.
Setting the stroke and motion of the feeding and presser feet.
Adjusting the potentiometer for automatic speed control based on stroke.
Adjusting the pneumatic lift mechanism for the sewing foot.
Setting the height for the sewing feet when locked in the 'up' position.
Setting the stopper screw to limit sewing foot lift and prevent collisions.
Adjusting the thread tension discs to open correctly during operation.
Setting the spring travel and tension for the thread controller.
Procedure to engage the safety clutch mechanism for hook protection.
Adjusting the torque setting of the safety clutch for overload protection.
Important general advice and precautions for machine lubrication.
Procedure for setting the oil quantity for the hook lubrication.
Instructions on how and when to change the sewing machine's lubricating oil.
Troubleshooting and checks for oil level and overflow issues.
Steps for correctly mounting the sewing machine head cover.
Detailed explanation of how the thread trimming sequence operates.
Setting the sideways position and height of the thread pulling knife.
Adjusting the counter knife and underthread clamp for effective thread cutting.
Setting the guide curve, swing range, and roller lever for thread trimmer.
Configuring parameters for the KFA-373 short thread trimmer.
Mechanical adjustments for the short thread trimmer, including cutting position.
Specific settings for the short thread trimmer with an oversized hook.
Adjusting the length of the last stitch before thread cutting.
Information on the thread clamp and its stroke adjustment settings.
Troubleshooting common faults for the short thread trimmer system.
Parameter settings for the KFA-573 short thread trimmer.
Mechanical adjustments for the KFA-573 short thread trimmer, including cutting position.
Setting the stitch length for thread trimming with the short thread trimmer.
Details on the thread clamp's function and main setting rules.
Troubleshooting common faults for the short thread trimmer system.
Defining and adjusting needle and thread lever positions.
Guide to setting parameters via the V810 and V820 control panels.
Procedure to reset all parameters to factory default settings.
Introduction to the automatic speed adaptation (Speedomat) function.
Configuring Speedomat using the V810 and V820 control panels.
Installation and setup for electro-pneumatic seam bartacking units.
Adjusting stroke and speed with the HP 13-7 Speedomat system.
Installation and operation of the 2nd stitch length option.
Setting up and operating the VA vertical cutter attachment.
Operating and adjusting the AE edge cutter and binder.
