Fitting the sewing lamp
4 Additional Instructions 581 - 00.0 - 02/2015
2 Fitting the sewing lamp
In order to be able to fit the parts set, you must remove the existing
components.
When doing so, comply with the following
Sequence:
1. Remove the clamping plates.
2. Remove the finger protection.
3. Detach the housing.
4. Detach the head cover.
5. Remove the head cover.
6. Remove the housing.
Now you can fit the new housing with the
printed circuit board.
WARNING
Risk of electric shock from live parts!
Dangerous injuries to life and limb possible.
The sewing light may only be fitted by qualified
specialists.
Switch off the machine and unplug the power plug.
Make sure the power plug cannot be
u
nintentionally reinserted.
To Next Page
Loading...
