What to do if DACextension box is not responding on DURKOPP ADLER 967?
If the DACextension box is not responding on your DURKOPP ADLER Sewing Machine: • Check the connection cables. • Check the LEDs of the DACextension box. • Perform a software update.
How to fix 'Position not reached' error on DURKOPP ADLER 967?
To fix a 'Position not reached' error on your DURKOPP ADLER Sewing Machine: • Check and change the controller settings if necessary. • Make mechanical adjustments to the machine, such as the thread cutting setting and belt tension. • Verify the position, ensuring the thread lever is at the top dead center.
What to do for an encoder error on DURKOPP ADLER Sewing Machine?
If you encounter an encoder error on your DURKOPP ADLER Sewing Machine, replace the encoder.
Why is the stitch loosening device not working on my DURKOPP ADLER 967?
Stitch loosening cannot be performed on your DURKOPP ADLER Sewing Machine.
What to do if there is an external EEprom communication error on DURKOPP ADLER 967 Sewing Machine?
If there is an external EEprom communication error on your DURKOPP ADLER Sewing Machine, switch off the control, wait until the LEDs are off, check the connection for the machine ID, and then switch the control on again.
What to do if the external synchronizer plug is not connected on DURKOPP ADLER 967?
If the external synchronizer plug (Sub-D, 9-pin) is not connected on your DURKOPP ADLER Sewing Machine: • Connect the cable of the external synchronizer to the control, using the correct connection (Sync). This is only required for machines with transmission. • Switch off the control, use the handwheel to turn, and switch on the control again. If the error is not corrected, check the encoder.
What to do if the internal EEprom is defective and external EEprom is not connected on DURKOPP ADLER Sewing Machine?
If the internal EEprom is defective and the external EEprom is not connected (emergency operating features only) on your DURKOPP ADLER Sewing Machine, replace the control.
What to do if DA stepper card 1 encoder plug is not connected on DURKOPP ADLER 967?
If the DA stepper card 1 encoder plug (Sub-D, 9-pin) is not connected on your DURKOPP ADLER Sewing Machine, connect the encoder cable to the control using the correct connection.
What to do if the pedal is not connected to DURKOPP ADLER Sewing Machine?
If the pedal is not connected to your DURKOPP ADLER Sewing Machine, connect the analog pedal.
What to do if there is an internal short circuit in DURKOPP ADLER 967 Sewing Machine?
If there is an internal short circuit in your DURKOPP ADLER Sewing Machine, replace the control.
Provides fundamental safety guidelines for operating the machine, including prohibitions and essential precautions.
Explains signal words like DANGER, WARNING, CAUTION, and associated symbols indicating hazard severity.
Defines intended use, outlines precautions, and states compliance with regulations.
Covers preparing the machine, switching on/off, needle and thread setup.
Covers checking delivery, removing transport locks, and assembling the stand.
Details electrical/pneumatic connections, assembly, and performing a test run.
Provides customer service contact and explains how to handle software messages and errors.
General| Brand | DURKOPP ADLER |
|---|---|
| Model | 967 |
| Category | Sewing Machine |
| Language | English |
To Next Page
