Operation
Operating Instructions 967 - 02.0 - 11/2016 65
4.12.2 Seam securement
When using yarn of exceptional thickness, you may find that
one bartack is not enough to secure the thread. In this case, it is
advisable to tie the ends of the yarn together in order to attain a
secure and stable seam end.
To secure the seam by tying the ends of the yarn together:
1. When finished sewing, pull the end of the thread at the begin-
ning of the seam to the underside of the sewing material.
2. Tie the ends of the thread together.
4.13 Sewing speed
The sewing speed has been set to the maximum speed at the
factory. The maximum speed cannot be exceeded.
The sewing speed increases and decreases proportionally with
the angle of the pedal when the pedal is pressed.
The sewing speed and the response of the setpoint device can
be adjusted using parameters (see Parameter list 967).
The OP1000 control panel can be used to lower the speed
(see Instructions for use DAC basic/classic).
To Next Page
Loading...
Need help?
General
