Setup
Operating Instructions 967 - 02.0 - 11/2016 99
2. Fit the reel stand arm (7) to the reel stand holder (3).
• upper position (1): with inclination adjustment
• lower position (4): without inclination adjustment
3. Tighten the reel stand arm (7) using the screws (2).
4. Set the desired angle of inclination at the upper position (1).
7.9 Electrical connection
Important
The voltage on the type plate of the sewing motor must correspond
to the mains voltage.
DANGER
Risk of death from live components!
Unprotected contact with electricity can result in
serious injuries or death.
Only qualified specialists may perform work on
electrical equipment.
To Next Page
Loading...
