Operation
Operating Instructions 967 - 02.0 - 11/2016 23
4.3 Inserting/changing the needle
Order
After switching to a different needle thickness, adjust the distance
between hook and needle and change the distance piece for the
loop support. If using a different needle system, you need to adjust
the height of the needle bar ( Service Instructions).
Disturbance
Disturbance after inserting a thinner needle:
• Missing stitches
• Thread damage
CAUTION
Risk of injury from sharp and moving parts!
Punctures possible.
Switch off the machine before you insert or
change the needle.
Do not reach into the needle tip.
NOTICE
Property damage may occur!
There is a risk of machine damage, needle breakage or
damage to the thread if the distance between hook and
needle is incorrect.
Check and, if necessary, readjust the distance to the hook tip
and the loop support after inserting a needle with a different
size.
Check and, if necessary, readjust the height of the needle
bar after inserting a needle with a different needle system.
Adjust the distance piece between driver and loop support
after inserting a needle with a different size ( Service
Instructions).
To Next Page
Loading...
Need help?
General
