Operation
24 Operating Instructions 967 - 02.0 - 11/2016
Disturbance after inserting a thicker needle:
• Damage to the hook tip
• Damage to the needle
• Damage to the loop support
Disturbance after inserting a shorter needle:
• Damage to the hook tip
• Damage to the needle
• Missing stitches
After inserting a longer needle:
• Damage to the hook tip
• Damage to the needle
• Missing stitches
Fig. 5: Inserting/changing the needle
To insert or change the needle:
1. Turn the handwheel until the needle (3) reaches the upper end
position.
2. Loosen the screws (2).
3. Pull the needle (3) down and out.
4. Insert the new needle.
Important
Align the needle in such a way that the groove (4) faces the hook.
5. Tighten the screws (2).
(1) - Needle bar
(2) - Screws
(3) - Needle
(4) - Groove
To Next Page
