Setup
Operating Instructions 967 - 02.0 - 11/2016 105
2. Turn the pressure controller until the pressure gage (2) indi-
cates the proper setting:
• Increase pressure = turn clockwise
• Reduce pressure = turn counterclockwise
3. Push the pressure controller (1) down.
7.11 Checking the lubrication
All wicks and felt bits of the machine head are soaked in oil at the
factory. The oil is conveyed to the reservoir during use.
This is why you should avoid filling too much oil during initial filling
( p. 80).
7.12 Performing a test run
When setup is complete, perform a test run to check the function-
ality of the machine.
To Next Page
Loading...
