MAINTENANCE
Changing Oil
• Place generator on a level surface.
• Run the generator for several minutes until the engine is warm. Turn off generator.
• Remove screws, then remove outer casing side cover.
• Remove the crankcase dipstick.
• Place an oil pan underneath the engine. Tilt generator to collect used oil. Allow oil to drain completely.
• Return generator to a level surface.
• Carefully add 4-Cycle engine oil (SAE 1 OW-30) to empty reservoir until oil reaches the outer edge of the oil fill hole
(Crankcase Dipstick hole).
• Use a clean rag to wipe up any spilled oil.
• Replace crankcase dipstick.
• Reinstall outer casing side cover and tighten screws.
Recommended Engine Oil: SAE 10W-30
Recommended Engine Oil Grade: API Service SE type or higher quality of engine oil.
Engine Oil Quantity: 0.35L (0.924 us gal)
_A CAUTION!
A CAUTION!
Do not tilt generator when adding oil. This could result in overfilling which could damage
the engine.
Make sure no foreign matter enters the crankcase
20
To Next Page
Loading...
