MAINTENANCE
Fuel Tank Filter
• To clean, remove fuel cap and filter.
• Clean filter with gasoline.
• Wipe the filter with a clean rag.
Install filter.
• Install fuel cap.
Fuel Filter
• To clean, remove screws, remove outer casing, and drain fuel.
• Lift and hold onto the clamp, then remove hose from tank.
• Take out fuel filter.
• Clean filter with gasoline.
• Wipe the filter with a clean rag and return filter to tank.
Install hose and clamp.
• Open fuel valve. Inspect for leakage.
• Install outer casing and tighten screws.
Storage and Transportation of the Generator:
When transporting the generator, turn the 3 in 1 Start Switch (ON / OFF and Choke) OFF. Keep the generator level to
prevent fuel spillage. Fuel vapor or spilled fuel may ignite.
• Remove any debris that has collected on the generator and around the muffler and control panel. Use a brush or vacuum
to remove loose dirt.
Inspect air cooling slots. Remove any debris if obstructed.
• For short-term storage, start the generator once every 7days.
• For semi-long term storage, add fuel stabilizer to prevent stale fuel from causing acid and gum deposits in the fuel system
and carburetor.
• For long-term storage, drain the fuel.
• Store indoors to prevent freezing and use aprotective cover to protect from dust.
• The generator must be Shipped, Run, and Stored in the upright position as seen
in this image.
22
To Next Page
Loading...
