Owner’s Manual – Electric Boosted Solar
6
Part No: H3100
Version: 10346D
Plumbing Connections
Safety Information
For safe performance this water heater
is tted with:
an over-temperature energy cut-out •
thermostat
a combination Pressure & •
Temperature Relief Valve.
These devices must not be tampered
with or removed. The water heater must
not be operated unless both of these
devices are tted and in working order.
The element cover should be removed
only by an electrician. The electrical
power supply switch must be turned
off and the fuse removed at the main
electrical supply switchboard before the
water heater electrical cover is removed.
The Pressure & Temperature Relief
Valve should be checked for adequate
performance or replaced at intervals
not exceeding 5 years, or less in areas
where local regulations apply. The lever
on the relief valve should be pulled to
operate the valve at least once every 6
months.
Temperature Protection
All solar water heaters have the ability
to produce hot water very quickly.
To reduce the risk of scald injury, it is
mandatory under the requirements of
Australian Standard AS/NZS3500.4.2
that a suitably approved temperature
control device be tted to the hot water
supply to outlets used primarily for
personal hygiene. This valve should be
checked at regular intervals to ensure its
operation and settings remain correct.
Note: All Dux solar water heaters are
supplied with tempering valves. Any
adjustment to the valve should be
made according to the manufacturer’s
recommendations.
To Next Page
Loading...
