Operation manual - Spider ILD01
48 / 52 rev. 10-01-05-2011
12 TROUBLESHOOTING
Nothing appears on the display
when the RC is turned on
Replace the battery with a charged
one
Charge the battery
Accumulator is discharged
Charge the battery
Check the fuse
Accumulator is disconnected
Attach terminal connectors to the
battery
Check/replace the cable lines
Check the fuse
Spark plug does not spark
Refill oil up to the required level
No signal or the mower is out of the
signal range
Check the aerial attachment / Move
closer to the mower
Emergency button on the mower is
pressed
The mower does not travel
properly/at all
Not enough oil in the hydraulic
circuit
Refill oil and de-aerate properly
Clean the fan area, wait till
oil cools down
Hydraulic pump filter is clogged
Mechanic elements of the
hydraulic drive are worn out
The mower cannot climb slopes
V-belts are not tensioned enough
Damaged hydraulic pump
servomotor
The mower vibrates when started
Blade carrier shaft is curved
Blade is not attached properly
Change the blade bolts and tighten
them properly
Unevenly worn out or damaged
blade
Grass is overgrown, too high
Mow only grass which is maximum
3x taller that the pre-set stubble
height. We recommend to mow the
grass, let it dry and mow it again
Worn/blunt cutting edge of the
blade
Sharpen or replace the blade
Wait till the grass dries
Set the engine speed to maximum