Dymo LabelManager Wireless PnP User Manual

19
LabelManager
®
Wireless PnP
User Guide
Caring for the Label Maker
Your label maker is designed to give you long and trouble-free service, while
requiring very little maintenance. Clean your label maker from time to time to keep
it working properly. Clean the cutter blade each time you replace the label
cassette.
To clean the cutter blade
1 Press and then pull
outward to open the side
cover of the label maker.
2 Remove the label cassette.
3 Press and hold the power
button.
4 While holding the power
button, press and release
the cutter button to move
the cutter blade.
5 Repeat step 3 until the
cutter blade is exposed.
See Figure 6.
6 Release the power button.
7 Use a cotton ball and alcohol to clean both sides of the blade.
The cutter blade is extremely sharp. Use caution when cleaning.
8 After cleaning the blade, press and release the cutter button to return the
cutter blade to the home position.
To clean the print head
1 Press and then pull outward
to open the side cover of the
label maker.
2 Remove the label cassette.
3 Use a small, soft brush or cotton
swab to wipe away dust and
other stray particles from the
inside of the label compartment.
4 Remove the cleaning tool from
inside the label compartment
cover.
5 Gently wipe the padded side of
the tool across the print head.
See Figure 7.
The print head is very delicate,
so use care when cleaning.
6 Replace the cleaning tool, insert
the label cassette, and close the
side cover.
Cutter
blade
Figure 6
Print head
Figure 7
Cleaning tool

Dymo LabelManager Wireless PnP Specifications

General

Brand	Dymo
Model	LabelManager Wireless PnP
Category	Label Maker
Language	English