Dymo LETRATAG 100T User Manual

4
Inserting the Batteries
The labelmaker uses four high-capacity AA alkaline batteries.
To insert the batteries
1. Remove the battery compartment
cover. See Figure 2.
2. Insert the batteries following the
polarity markings (+ and –).
3. Replace the cover.
Ç Remove the batteries if the
labelmaker will not be used for a long
period of time.
Figure 2
Connecting the Optional Power Adapter
An optional 9 Volt,1.5 A power adapter can also be used to power
the labelmaker. Connecting the AC adapter to the labelmaker
disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top of
the labelmaker.
2. Plug the other end of the power adapter into a power outlet.
LT Momentum WEU.indd 4 09-01-2007 17:23:36

Dymo LETRATAG 100T Specifications

General

Model	LETRATAG 100T
Category	Label Maker
Keyboard Type	QWERTY
Print Resolution	160 dpi
Tape Width	12 mm
Print Technology	Thermal transfer
Memory	9 label memory
Number of Styles	5
Auto Power Off	Yes
Type	Handheld
Label Width	12 mm
Display	13 character LCD
Tape Type	LetraTag
Tape Compatibility	LetraTag tapes
Label Type	Plastic
Font Styles	Normal, Bold, Italic, Outline
Font Sizes	Small, Large
Text Alignment	Left, Center
Power Source	4 x AA batteries (not included)
Battery	4 x AA (not included)