EasyManua.ls Logo

Dyna-Glo BF10DTDG-4 - User Manual

Dyna-Glo BF10DTDG-4
60 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
VENT-FREE
BLUE FLAME
GAS WALL HEATER
MODEL #BF10DTDG-4
BF20DTDG-4
BF30DTDG-4
GBF30DTDG-4
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
WARNING: This appliance is equipped for
Natural and Propane gas. Field conversion is
not permitted.
- Do not store or use gasoline or other ammable vapors and Iiquids in vicinity of this or
any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the re department.
- Installation and service must be performed by a qualied installer, service agency or the
gas supplier.
This is an unvented gas-red heater. It uses air (oxygen) from the room in which it is
installed. Provisions for adequate combustion and ventilation air must be provided.
Refer to Air For Combustion and Ventilation section on page 8 of this manual.
This appliance may be installed in an aftermarket, permanently located, manufactured (mobile)
home, where not prohibited by local codes.
This appliance is only for use with propane or natural gas.
This appliance is equipped with a simple means to switch between propane and natural gas.
Field conversion by any other means including the use of a kit is not permitted.
C US
WARNING: Do not attempt to access or change
the setting of the fuel selection means.
Access to and adjustment of the fuel selection means
must only be performed by a qualied service person
when connecting this appliance to a specied fuel
supply at the time of installation.
Change of the selector setting to other than the fuel type
specied at the time of installation could damage this
appliance and render it inoperable.
The installer shall replace the access cover before
completing the installation and operating this appliance.
C US
ANS Z21.11.2-2016
Gas Fired Room Heaters
Volume II - Unvented Room Heaters
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-447-4768, 8:30 a.m. – 4:30 p.m., CST, Monday – Friday or
email us at customerservice@ghpgroupinc.com.
IMDFBFG4 - 2019-03-25
Patent Pending Dual
Fuel System

Table of Contents

Questions and Answers

  • R
    Robert RodriguezSep 12, 2025
    Why does my Dyna-Glo BF10DTDG-4 Gas Heater smell?
    • P
      Philip FranklinSep 12, 2025
      If your Dyna-Glo Gas Heater is producing unwanted odors: * The heater may be burning vapors from paint, hair spray, glues, etc. Ventilate the room and stop using odor-causing products while the heater is running. * There might be a gas leak. Locate and correct all leaks. * The fuel supply may be low. Refill the supply tank (Propane/LP models).
  • A
    Andrea GravesSep 14, 2025
    Why isn't the fan on my Dyna-Glo BF10DTDG-4 spinning?
    • A
      Anthony CarrilloSep 14, 2025
      If the fan on your Dyna-Glo Gas Heater is not spinning: * Make sure there is power to the fan. Verify the fan is plugged in and set to 'MAN' or 'AUTO'. * If the fan is set to 'AUTO', allow 5-10 minutes for the fan to engage. * The fan motor may be bad. Replace the fan.
  • S
    Stacey ThompsonSep 16, 2025
    Why is the fan on my Dyna-Glo Gas Heater so loud?
    • V
      victoriavegaSep 16, 2025
      If your Dyna-Glo Gas Heater fan is making a loud noise: * The fan housing or blades may be dirty. See the manual section on 'Cleaning Fan'. * The fan rotation may be blocked. Verify wiring is not in the fan path. * The fan may be defective. Replace the fan.
  • T
    Theresa CamposNov 18, 2025
    Why does my Dyna-Glo BF10DTDG-4 shut off after a few minutes?
    • D
      Donna HurstNov 18, 2025
      If your Dyna-Glo Gas Heater shuts off after running for a few minutes, here are some things to check: 1. Make sure the gas supply is turned on and the equipment shutoff valve is open. 2. Ensure the control knob is fully pressed in while pressing the ignitor module. 3. If the unit was recently installed, continue holding down the control knob and repeat the igniting operation to remove air from the gas lines. 4. Inspect the ODS/pilot for clogs. Clean or replace the ODS/pilot assembly if needed. 5. The gas regulator setting might be incorrect, consider replacing the gas regulator. 6. Confirm the control knob is in the PILOT position. 7. If using propane, check for a depleted gas supply and contact your local propane company if necessary. 8. If the gas setting regulator or selector v...

Dyna-Glo BF10DTDG-4 Specifications

General IconGeneral
BrandDyna-Glo
ModelBF10DTDG-4
CategoryGas Heater
LanguageEnglish

Related product manuals