EasyManua.ls Logo

Dyna-Glo BFSS10LPT-2P - User Manual

Dyna-Glo BFSS10LPT-2P
60 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VENT-FREE
BLUE FLAME
GAS WALL HEATER
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
WARNING: This appliance is equipped for
(natural or propane) gas. Field conversion is not
permitted.
- Do not store or use gasoline or other ammable vapors and Iiquids in vicinity of this or
any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the re department.
- Installation and service must be performed by a qualied installer, service agency or the
gas supplier.
This is an unvented gas-red heater. It uses air (oxygen) from the room in which it is
installed. Provisions for adequate combustion and ventilation air must be provided.
Refer to Air For Combustion and Ventilation section on page 8 of this manual.
This appliance may be installed in an aftermarket, permanently located, manufactured (mobile)
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate.
This appliance is not convertible for use with other gases.
C US
C US
ANS Z21.11.2-2013
Gas Fired Room Heaters
Volume II - Unvented Room Heaters
IMBFSS - 2018-03-21
MODEL #
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-447-4768, 8:30 a.m. – 4:30 p.m., CST, Monday – Friday or
email us at customerservice@ghpgroupinc.com.
Propane
BFSS10LPT-2P
BFSS20LPT-2P
BFSS30LPT-2P
Natural Gas
BFSS10NGT-2N
BFSS20NGT-2N
BFSS30NGT-2N

Table of Contents

Questions and Answers

  • J
    Jennifer BellSep 2, 2025
    Why is there a delayed ignition of burner(s) in my Dyna-Glo BFSS10LPT-2P Gas Heater?
    • K
      Kenneth PopeSep 2, 2025
      If your Dyna-Glo Gas Heater experiences delayed ignition of the burner(s), contact your gas supplier. Alternatively, try cleaning the burner.
  • T
    Timothy MendezAug 31, 2025
    Why is there a high yellow flame during combustion in my Dyna-Glo BFSS10LPT-2P?
    • D
      dawnshawAug 31, 2025
      If you observe a high yellow flame during burner combustion in your Dyna-Glo Gas Heater, check the burner for dirt and debris and clean it if necessary. If the issue persists, the gas regulator may need to be replaced.
  • S
    Stephen FullerAug 29, 2025
    What to do if I smell gas when my Dyna-Glo BFSS10LPT-2P control knob is OFF?
    • M
      Michael BaxterAug 29, 2025
      If you smell gas even when the control knob of your Dyna-Glo Gas Heater is in the OFF position, there may be a gas leak. Locate and correct all leaks. If you cannot resolve the issue, contact customer service.
  • L
    Lucas McclureAug 27, 2025
    Why is there a gas odor during combustion in my Dyna-Glo BFSS10LPT-2P Gas Heater?
    • T
      tcastilloAug 27, 2025
      If you notice a gas odor during combustion in your Dyna-Glo Gas Heater, take apart the gas tubing and remove any foreign matter. Also, locate and correct any gas leaks.
  • B
    beverlymunozAug 26, 2025
    What to do if my Dyna-Glo BFSS10LPT-2P shuts off in use (ODS operates)?
    • R
      Robert VegaAug 27, 2025
      If your Dyna-Glo Gas Heater shuts off during use, but the ODS operates, open a window and/or door for ventilation. If that doesn't solve the issue, contact your local gas supplier or clean the ODS/pilot.
  • A
    Anthony LambAug 25, 2025
    Why won't the burner(s) light on my Dyna-Glo Gas Heater after the pilot is lit?
    • M
      marvin38Aug 25, 2025
      If the burner(s) on your Dyna-Glo Gas Heater do not light after the ODS/pilot is lit, try turning the thermostat knob to a higher setting. You can also try cleaning the burner orifice. If the problem persists, contact customer service or your gas supplier for assistance.
  • J
    Justin SparksAug 22, 2025
    What to do if the Dyna-Glo Gas Heater pilot lights but goes out when I release the control knob?
    • A
      Angela GriffinAug 22, 2025
      If the ODS/pilot light of your Dyna-Glo Gas Heater lights but the flame goes out when you release the control knob, ensure that you are pressing the control knob fully. After the ODS/pilot lights, keep the control knob pressed in for 30-60 seconds. Also, fully open the equipment shutoff valve and hand tighten gas connections until they are snug, then tighten an additional ¼ turn. If the issue continues, the thermocouple may need to be replaced. For further assistance, contact customer service or your gas supplier to check and adjust the inlet pressure.

Dyna-Glo BFSS10LPT-2P Specifications

General IconGeneral
ModelBFSS10LPT-2P
BTU Output10, 000 BTU
Fuel TypeLiquid Propane
Ignition TypePiezo Ignition
Heating Area300 sq. ft.
Oxygen Depletion Sensor (ODS)Yes
Safety Shut-offYes
Safety FeaturesODS, Safety Shut-off
TypeBlue Flame
Mounting LocationWall or Floor

Related product manuals