Dyna-Glo DGU951SDE - Page 11

11
Remove the pre-installed screws on the door
handle (E) and attach the handle to the upper
door on the cabinet assembly (A) using the pre-
installed screws.
Remove the lower drawer assembly (J) from the
cabinet assembly (A). Remove the pre-installed
screws on the drawer handle (E) and attach the
handle to the drawer assembly (J) using the pre-
installed screws.
3.
4.
ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
E
3
A
AA
A
4
E
J
AA
M4 x 35 mm
Screw
x 4
AA
M4 x 35 mm
Screw
x 4
AA