Dynacord C1300FDi-US User Manual

Notice!
Controlling multiple amplifiers via Dynacord control software: It is recommend to use a powered
USB hub if the user wishes to control amplifiers with one cable to their computer. USB range
extenders can also be used to remotely position the software control interface longer distances
from the amplifiers.
Due to the great number of USB hubs and extenders, it is not possible to verify and test all
brands and models for use with this product.
To find current user documentation, firmware, or software visit our product related
information at www.dynacord.com.
Factory presets
L Series and C Series amplifiers have a selection of factory presets on board. These are
generic settings to be used as a starting point for configuration that do not require a
dedicated speaker setting, but only some basic sound adjustments. The following content is
based on the first release, future firmware updates might include additional or updated
settings.
Name Input Routing Parameters
F01 Linear Dual In A > Out A In B >Out B All flat, no links
F02 Linear Mono A In A > Out A In A >Out B All flat, no links
F03 Stereo Linked In A > Out A In B >Out B All flat, CH A & B linked
F04 Sub & Top #1 In A > Out A In A > Out B BW18dB x-over @ 100Hz
F05 Sub Stereo #1 In A > Out A In B >Out B BW18dB Lo-Pass @ 100Hz
F06 Top Stereo #1 In A > Out A In B > Out B BW18dB Hi-Pass @ 100Hz
F07 Sub & Top #2 In A > Out A In A > Out B LR24dB x-over @ 100Hz
F08 Sub Stereo #2 In A > Out A In B > Out B LR24dB Lo-Pass@ 100Hz
F09 Top Stereo #2 In A > Out A In B > Out B LR24dB Hi-Pass @ 100Hz
F10 LPN Stereo In A > Out A In B > Out B LPN filter for enhanced LF
Table 7.2: L Series factory presets
Name Input Routing Parameters
F01 Linear Dual In A > Out A In B >Out B All flat, no links
F02 Linear Mono A In A > Out A In A >Out B All flat, no links
F03 Stereo Linked In A > Out A In B >Out B All flat, CH A & B linked
F04 HP50Hz-Dual In A > Out A In B >Out B Hi-Pass 18dB @ 50Hz
F05 HP50Hz-Mono In A > Out A In A >Out B Hi-Pass 18dB @ 50Hz
F06 HP50Hz-Stereo In A > Out A In B >Out B Hi-Pass 18dB @ 50Hz, CH A &
B linked
F07 LPN Stereo In A > Out A In B >Out B LPN filter for enhanced LF
C1300FDi
7.3
26 en | Power amplifier menu navigation
L Series and C Series FIR-Drive Power
Amplifiers
2017.10 | 02 | F.01U.327.801 Installation manual Bosch Sicherheitssysteme GmbH

Dynacord C1300FDi-US Specifications

General

Brand	Dynacord
Model	C1300FDi-US
Category	Amplifier
Language	English