Technical Specifications: X1201
Amplifier at rated conditions, 8 ohms load, unless otherwise specified.
X1201
Load Impedance 8 ohms 4 ohms 2 ohms
Maximum Midband Output Power 750 W 1200 W 1600 W
THD = 1%, 1kHz
Rated Output Power 500 W 1000 W ————
THD < 0.2%, 20Hz ... 20kHz
Max. Single Channel Output Power 850 W 1450 W 1700 W
Dynamic-Headroom, IHF-A
Maximum RMS Voltage Swing 86 V
THD = 1%, 1kHz
Voltage Gain 33 dB
at 1kHz
Slew Rate 40 V/µs
at 1kHz
Power Consumption 870 W
at 1/8 maximum output power @ 4 ohms
Input Sensitivity 1.4 V
at rated output power @ 4 ohms, 1kHz
THD at rated output power, < 0.05 %
MBW = 80kHz, 1kHz
IMD-SMPTE < 0.08 %
60Hz, 7kHz
DIM30 < 0.03 %
3.15kHz, 15kHz
Frequency Response 13 Hz ... 45 kHz
-1dB, ref. 1kHz
Power Bandwith 10 Hz ... 50 kHz
THD = 1%, ref. 1kHz, half power @ 4 ohms
Input Impedance 20 kohms
20Hz ... 20kHz, balanced
Damping Factor > 300 / > 200
at 100Hz / 1kHz, 8 ohms
Signal to Noise Ratio 106 dB
A-weighted, non internal summing mode
Power Requirements 240V,230V,120V,100V / 50Hz ... 60Hz,factory configured
Protection Audio limiters, High temperature, DC, HF, Back-EMF,
Peak current limiters, Inrush current limiters, Turn-on delay
Cooling Front-to-rear, 3-stage-fans
Safety Class I
Dimensions
(W x H x D), mm 483 x 132.5 x 426
Weight 17 kg
Optional
Input transformer NRS 90208 (121 641)
Rear-rackmount 15,5" NRS 90235 (112 733)
Rear-rackmount 18" NRS 90223 (112 701)
SPECIFICATIONS
32
To Next Page
Loading...
Need help?
General
