Rhino to RHINO2 Conversion Guide Page 4
Introduction
This document shows you how to retrofit a RHINO2 scooter control system. It is important that you
read and follow these instructions carefully. Please adhere to all warnings and steps.
To complete the installation, you will need the following:
A copy of the RHINO2 Installation Manual
A RHINO2 controller to replace the Rhino
Cable adaptors for battery, motor, park brake and tiller head.
The Wizard for setting parameters and optionally, a DX-HHP (hand-held programmer) for
calibrating the Throttle.
Programmer adaptors: DWIZ-ADAPT and DR-PRGLM02 (see Programming in the Further
information section at the back of this guide)
Warning:
Follow these instructions carefully. The RHINO2’s current capability is higher
than Rhino. Failure to follow these settings can result in damage to the scooter
or serious injury to the user.
Warning:
This manual should be read in conjunction with the RHINO2 Installation
Manual and the procedure should only be carried out by suitably trained
personnel.
Make sure that you have a copy of the RHINO2 Installation Manual at hand. This is important for
details of mounting the new controller, setting the controller’s profile, and detailed further
If you have any difficulty with the instructions in this guide, then please consult your scooter
To Next Page
Loading...
Need help?
General
