GBK51948 RHINO2
Installation Manual Issue 5
Warning
Do not drive the vehicle if the controller indicates that the batteries are low, since the vehicle may stop
operating and the user may become stranded. If the batteries become completely empty, the vehicle will stop
suddenly and the batteries may be damaged.
Warning
Make sure that the battery charger that is used with the vehicle has a drive inhibit function that is correctly
connected for use with the controller. The maximum voltage on the inhibit pin must not exceed 3 V if a battery
voltage is to be detected when the battery charger is connected. If you are not sure, ask your dealer or vehicle
manufacturer.
Warning
The controller can cause the vehicle to come to a sudden stop. If this can be dangerous to the operator, the
installer must install a seat belt, and the operator must wear this seat belt.
Warning
Do not use the park brake release on a slope or when an occupant is on the scooter.
Warning
Performance adjustments must only be made by healthcare professionals, or by persons who completely
understand the programming parameters, the adjustment process, the configuration of the vehicle, and the
capabilities of the driver. Wrong settings can make the vehicle uncontrollable or unstable. An uncontrollable or
unstable vehicle can cause an unsafe situation such as a crash, with the risk of serious injury to the driver or
bystanders, or damage to the vehicle or surrounding property.
Warning
Performance adjustments must only be made indoors or outdoors in dry conditions.
Warning
It is the responsibility of the scooter manufacturer to inform the scooter user about the scooter's stopping
distances.
Warning
If a fault is indicated on the scooter, the battery should be isolated before transporting to service.
Note
For users within the European Union (EU), any serious incident that has occurred in relation to the device
should be reported to Dynamic Controls and to the competent authority of the EU State in which you reside.
Note
Do not try to open or disassemble any case - there are no user-serviceable parts inside.
l
The operator has the responsibility to keep the vehicle in a good safe operating
condition. To protect all the components (for example the cables) from damage, the
operator must fasten them in optimum positions.
l
Do not touch the connector pins. If you touch the pins, they can become dirty or they
can be damaged by electrostatic discharge.
Page 148 - Appendices
To Next Page
Loading...
Need help?
General
