GBK51948 RHINO2
Installation Manual Issue 5
6.5.1 User Personalisation
6.5.1.1 Sleep Timer
Parameter Possible Values Default HHP Lite Std Adv
Sleep Timer 0 - 30min 30min
✓ ✓
The RHINO2 automatically "goes to sleep" if the throttle has been in the Neutral position for
Sleep Timer minutes. When the RHINO2 sleeps, it is partially turned off to reduce energy
consumption and to make sure that the scooter does not move if the user accidentally
moves the throttle. In Sleep Mode, the scooter does not respond to commands.
To wake up the RHINO2, take the action that is selected with Wakeup Style.
If Wakeup Style is set to 'Key + Throttle', the Status Light gives a short flash every 5
seconds during sleep mode.
To disable Sleep Mode, set Sleep Timer to zero.
6.5.1.2 Wakeup Style
Parameter Possible Values Default HHP Lite Std Adv
Wakeup Style
Key + Throttle
Key Only
Key Only
✓
Defines how the controller will wake up from sleep.
Key Only — Only the key switch wakes up the controller (by turning the key off and then on
again).
Key + Throttle — The key switch as well as any throttle movement wakes up the controller.
Note
If the value of Sleep Timer is zero, the value of Wakeup Style is ignored.
6.5.1.3 Swap Throttle Direction
Parameter Possible Values Default HHP Lite Std Adv
Swap Throttle Direction No / Yes No
✓ ✓ ✓ ✓
This parameter is normally only used when Throttle Type is set to 'Wig-wag'. For single-
ended and uni-polar throttles, use a Forward/Reverse switch instead (see Pin [x] Function).
If this parameter is used in conjunction with a Forward/Reverse switch, then it will invert
the polarity of the Forward/ Reverse switch.
Yes — The polarity of the throttle is reversed. Moving the throttle in the direction that
normally causes forward movement now results in reverse movement while the reverse
buzzer beeps. Typically used for left-handed operation.
No — The polarity of the throttle is normal. Typically used for right-handed operation.
Note
The Motor Reverse parameter also reverses the direction of the scooter, but it does not swap the behaviour of
the reversing buzzer or the speed limit parameters. If Motor Reverse is set to 'Yes', the reversing buzzer will
Page 72 - Programming
To Next Page
Loading...
Need help?
General
