Dynapac CC102C Maintenance Manual

22 CC102/C/122/C/132/142/C M102EN4
DEUTZ
Run the engine warm before draining the oil.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors.
(Risk of carbon monoxide poisoning).
Switch off the engine and apply the par-
king brake.
Place a receptacle that holds at least 8 quarts
under the drain plug. Collect the oil and dis-
pose of it properly.
Risk for burns when draining hot oil. Pro-
tect your hands.
Unscrew the oil drain plug (1).
Allow all of the oil to drain off and refit the plug.
Fill with fresh engine oil; see the Lubricant specification
or the engine manual for the correct grade of oil. Check
the dipstick to ensure that the engine oil level is correct;
see the engine manual for details.
Remove and discard the oil filter (1) and fit a new one.
Make sure that the belt (2) is free from cracks or other
damage. Replace as necessary.
Check the belt tension; if you can press it down with
your thumb more than 10 mm (3/8") half way between
the belt pulleys, it needs tightening.
See engine manual for detailed instructions on
changing oil and filters, and for belt tightening.
Start the engine and check tightness of oil filter and
drain plug.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors.
(Risk of carbon monoxide poisoning).
Refit the engine protective plate.
Engine – Oil change
1
Fig. 32 Engine compartment, right side
1. Oil drain
Oil filter – Replacement
12
Fig. 34 Diesel engine (Isuzu)
1. Oil filter
1
Fig. 33 Diesel engine (Deutz)
1. Oil filter
2. V belt
EVERY 500 HOURS OF OPERATION (Every three months)

Dynapac CC102C Specifications

General

Brand	Dynapac
Model	CC102C
Category	Construction Equipment
Language	English