Safety - when operating
ICC1200-1EN2.pdf 2011-03-21
Slopes
Fig. Operating on slopes
Max 20° or 36%
This angle has been measured on a hard, flat surface
with the machine stationary.
The steering angle was zero, the vibration was
switched OFF and all tanks were full.
Always take into consideration that loose ground,
steering the machine, vibration on, machine speed
across the ground and raising the center of gravity can
all cause the machine to topple at smaller slope
angles than those specified here.
It is recommended that ROPS (Roll Over
Protective Structure) or a ROPS approved cab,
is always used when driving on slopes or
unsafe ground.
It is recommended that ROPS (Roll Over
Protective Structure) or a ROPS approved cab,
is always used when driving on slopes or
unsafe ground.
8
To Next Page
Loading...
Need help?
General
