Maintenance - 1000h
ICC1200-1EN2.pdf2011-03-21
Hydraulic fluid reservoir - Draining
Fig. Left frame side
1. Drain plug
1
Condensate in the hydraulic tank is drained via the
plug (1). This should be done when the roller has
stood still for some time, e.g. during the night.
Be very careful during draining. Do not drop the
plug or else all the hydraulic fluid will flow out.
Be very careful during draining. Do not drop the
plug or else all the hydraulic fluid will flow out.
Drain as follows:
Place a container under the plug (1). Loosen and allow
any condensate to run out. Tighten the plug.
Replacing the fuel filter
Fig. Engine compartment
1. Fuel filter
1
Place a container underneath to collect fuel that
runs out when the filter is released.
Place a container underneath to collect fuel that
runs out when the filter is released.
Screw off the fuel filter (1). The filter is of the
disposable type and cannot be cleaned. Han in to
environment-friendly station.
Refer to the engine manual for detailed
instructions when replacing the fuel filter.
Refer to the engine manual for detailed
instructions when replacing the fuel filter.
Start the engine and check that the fuel filter is tight.
Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning.
Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning.
85
To Next Page
Loading...
Need help?
General
