Maintenance - 250h
ICC1200-1EN2.pdf2011-03-21
Maintenance - 250h
Park the roller on a level surface.
The engine must be switched off and the
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
Park the roller on a level surface.
The engine must be switched off and the
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Coolers
Checking - Cleaning
Fig. Engine compartment
1. Water cooler
2. Hydraulic fluid cooler
2
1
Make sure that the air flow through the coolers (1) and
(2) is unobstructed. Dirty coolers are blown clean with
compressed air or washed clean using a
high-pressure water cleaner.
Blow air or direct water through the cooler in the
opposite direction to that of the cooling air.
Take care when using a high-pressure water jet.
Do not hold the nozzle too near the cooler.
Take care when using a high-pressure water jet.
Do not hold the nozzle too near the cooler.
Wear protective goggles when working with
compressed air or high-pressure water jets.
Wear protective goggles when working with
compressed air or high-pressure water jets.
75
To Next Page
Loading...
Need help?
General
