Dynapac CP2100 - Page 93

Maintenance - Every 250 hours
2018-02-08 4812325555EN 89
Lubricate the upper/lower pivot bearing
1. Lubricate the grease fitting of the upper pivot bearing (1)
and the grease fitting of the lower pivot bearing (2)
operating the grease gun manually with five pump strokes.
2. Use the grease according to the lubricant specifications
recommended by DYNAPAC.
Replace the air dryer filter
To replace the filter, empty the compressed air and unscrew the
cartridge with suitable tool.
Clean and grease the sealing surfaces and the fixing screw.
Manually screw the cartridge until there is resistance, and
tighten half turn.
Fig. – Air dryer filter
1. Cartridge
1
2
Fig. - Pivot bearings
1. Upper pivot bearing grease fitting
2. Lower pivot bearing grease fitting
1