Dynapac CP2100 - Maintenance - Every 1,000 hours; Replace the engine fuel filter; Replace the air dryer filter

Maintenance - Every 500 hours
90 4812325555EN 2018-02-08
Quarterly (Every 500 hours of operation)
Park the roller on a level surface.
When checking and adjusting the machine,
always turn off the engine and make sure the
forward/backward lever is in the neutral
position.
When the engine is off in enclosed places, make
sure there is a good ventilation, to prevent
carbon monoxide poisoning.
Replace the engine fuel filter
The fuel filter is located in front of the accumulators, on the left
side of the engine compartment.
1. Unscrew the bottom of the filter and drain the water. Next,
screw the unit in its place again.
2. Fit the fuel filter in the correct place, turn on the engine and
check if the filter is well sealed.
Replace the air dryer filter
To replace the filter, empty the compressed air and unscrew the
cartridge with suitable tool.
Clean and grease the sealing surfaces and the fixing screw.
Manually screw the cartridge until there is resistance, and
tighten half turn.
Fig. – Air dryer filter
1. Cartridge
Fig. – Engine compartment
1. Filter
1
1