Dynapac LF90 User Manual

14
LF90 ILF090EN2
OPERATION – HONDA GX160
1. Check the oil level in the engine.
2. Fill the fuel tank with fuel.
3. Check that all operating controls are working.
Starting the engine
4. Open the fuel cock.
5. Turn the engine switch to position I.
6. Put the throttle lever to middle position.
7. Close the choke if the engine is cold; if the engine is
warm or the ambient temperature high push it in half
way or let it stay open.
1/2
Before start
4
6
5
7
8. Pull back the handle slowly until resistance is felt, let
the handle move forward and then pull sharply to
start the engine. Do not allow the starter handle to hit
the engine. Release carefully to prevent damage to
the starting device.
9. While the engine is warming up, move the choke
control slowly to the right to open the choke fully.
9
Stopping the engine
1. Throttle in neutral position. Let the engine idle a few
minutes.
2. To stop the engine, turn the engine switch to O.
3. Close the fuel cock.
3
1
2
L000247A
L000155A
L000248A
L000153A
L000050A
8
L000039BL000077A
1
2

Dynapac LF90 Specifications

General

Brand	Dynapac
Model	LF90
Category	Power Tool
Language	English