7LF90 ILF090EN2
SAFETY WHEN DRIVING
Slopes
Driving on slopes
Tipping angle on side slopes
When driving near an edge, at least two thirds of the
plate must be on firm solid ground.
If the machine tips over, switch off the
engine before attempting to lift the ma-
chine.
Make sure that the work site is safe. Wet and loose
earth reduces manoeuvrability especially on sloping
ground. Always observe particular caution on sloping
and uneven terrain.
Where possible, avoid all driving across a
slope. Instead, drive up and down on slop-
ing ground.
Never work on slopes that are greater than the capabil-
ity of the machine. Maximum slope of the machine in
operation is 20° (depending on condition of the ground).
The tilting angle is measured on a hard, level surface
with the machine stationary. Vibration switched OFF
and all tanks full. Remember that loose ground, vibra-
tion switched ON, and driving speed can all cause the
machine to topple even on a smaller slope than speci-
fied here.
Never leave the machine unattended with
the engine running.
Driving near an edge
Machine location when operating
on edges
Max 20°
or 36%
L000602A
Max 20°
or 36%
L000601A
At least
2/3
L000600A
To Next Page
Loading...
Need help?
General
