EasyManuals Logo

dynarex Resp-O2 User Manual

dynarex Resp-O2
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16 Handheld Pulse Oximeter (Reorder No. 36403)
SECTION HEADER2. GENERAL DESCRIPTIONS (Continued)
2. Install 2 batteries as indicated by the polarity sign.
NOTE: Be sure to insert the batteries in the correct
polarity, as indicated by polarity markings (+ and -)
inside the battery cover.
3. Close battery cover: Close the battery cover and rotate
the screw to the
position, and the batteries are locked.
Make sure that the polarity of the batteries is correct,
otherwise the unit cannot operate normally.
Battery Life and Replacement
When the low-power indication lamp is lighted, please
replace the batteries with new ones as needed.
Always turn the unit off before replacing the batteries.
Dispose of the used batteries according to the applicable
local regulations.
WARNINGS!
If battery contents should get into your eyes, immediately rinse
with plenty of clean water. Consult a doctor immediately.
CAUTIONS!
Do not use batteries not specied for this unit.
Do not insert the batteries with the polarities in the wrong
direction.
Do not dispose of batteries in re.
If battery contents should get on your skin or clothing,
immediately rinse with plenty of clean water.

Other manuals for dynarex Resp-O2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the dynarex Resp-O2 and is the answer not in the manual?

dynarex Resp-O2 Specifications

General IconGeneral
Branddynarex
ModelResp-O2
CategoryRespiratory Product
LanguageEnglish

Related product manuals