dynarex Resp-O2 - 8. Beep Control and Troubleshooting; Beep On;Off Functionality

Handheld Pulse Oximeter (Reorder No. 36403) 31
7. ALARM SETTING (Continued)
8. BEEP ON/OFF
E 11: The value of pulse rate is lower than the low limit.
E 12: The value of pulse rate is higher than the high limit.
E 13: Power supply is insufcient.
When E9, E10, E11 or E12 occurs, the value of
parameterwillash.
• Check the error code.
• Press the right key under normal screen, it will indicate an
error code. To return to normal screen please press menu
button again.
WARNING!
When alarm occurs, DO as follows:
• Check which type of alarm is on.
• Check patient’s condition if parameter alarm is on.
• Make the alarm mute if necessary.
• Check whether the alarm is in proper condition in case
of no warning.
Press the menu key ve times under the normal screen to enter
access to this function, the associated screen will be displayed.
Press up or down key to set the pulse beep on/off.