dynasonics TFXL series - DTTN V-Mount and W-Mount Transducer Installation

PARAMETER CONFIGURATION USING ULTRALINK SOFTWARE
The flow meter must be programmed with the UltraLink software utility. The software is used to configure, calibrate and
communicate with TFXL flow meters. Additionally, it has numerous troubleshooting tools to make diagnosing and correcting
installation problems easier.
System Requirements
The software requires a PC-type computer, running Windows 2000, Windows XP, Windows Vista or Windows 7
operating systems.
Additional Parts Required for Conguration
Part Number Description
D010-0204-001 Configuration cable kit
D005-2116-004 USB-to-DB9 converter (required if PC does not have a serial port)
Installation
1. From the Windows Start button, choose the Run command. From the Run dialog box, use Browse to navigate to the
UltraLink_Setup.exe le and double-click.
2. The UltraLink Setup will automatically extract and install on the hard disk. The UltraLink icon can then be copied to
the desktop.
OTE:N If a previous version of this software is installed, it must be un-installed before a new version of the software can be
installed. Newer versions will ask to remove the old version and perform the task automatically. Older versions must
be removed using the Microsoft Windows Add/Remove Programs applet.
OTE:N Most PCs will require a restart after a successful installation.
Initialization
1. If the PC has a serial port, connect the PC to the TFXL meter with the D010-0204-001 cable kit.
If the PC has no serial port, connect the PC to the TFXL meter with the D010-0204-001 cable kit and the D005-2116-004
USB converter connected in series.
10 D
FLOW METER MOUNTING ORIENTATION
PC INTERFACE
CABLE
ULTRALINK
TM
PC INTERFACE
CABLE
PC INTERFACE
Figure 30: PC connections
OTE:N Power up the transmitter prior to running this software.
OTE:N While the serial cable is connected, the frequency outputs are disabled.
2. Double-click the UltraLink icon to start the software.
The UltraLink software will attempt to connect to the transmitter. If communications cannot be established, you will be
prompted to select a Com Port and Com Port Type.
Parameter Conguration Using UltraLink Software
Page 29 April 2016 TTM-UM-00369-EN-03