Dynaudio AIR 20 - AIR Setups

AIR Menu structure and parameters
Dynaudio Professional AIR reference manual – 2014-09-28 26
Setup menu ►
Monitor calibration
Use the calibration menu to calibrate each monitor in
your AIR System.
This section only describes the basic parameters of the
monitor calibration submenu. For more information re-
garding monitor placement and calibration, see “Plac-
ing the monitors” on page 48 and “Calibrating the
main monitors” on page 57.
Calibrating monitors in your AIR system
►
From the home screen, press the ENTER key.
►
Press the DOWN key until “Setup menu” is dis-
played.
►
Press the ENTER key.
►
Press the DOWN key until “Calibrate monitor” is
displayed.
►
Press the ENTER key.
►
Press the UP and DOWN keys to select a monitor.
►
Press the ENTER key.
►
Press the UP and DOWN keys to select a calibra-
tion parameter.
►
Press the ENTER key to activate the selected
parameter for editing.
►
Press the UP and DOWN keys to set the selected
parameter to the desired value.
►
Press the ENTER key to conrm your selection.
►
Press the EXIT key to move up one level in the
hierarchy and select another parameter for editing,
or
►
Press the EXIT key repeatedly to return to the
home screen.
Notes regarding the LFE channel
Please note that in general the LFE channel should be
mixed with +10 dB headroom.
If you are not able to boost your LFE monitor output
from your console, +10 dB gain can be added on your
AIR BASE input. Most format encoders / decoders take
the LFE boost into account, meaning that you should
leave the AIR BASE LFE gain at 0 dB when playing
back a DTS or DOLBY encoded material on your AIR
system. LFE gain is set at 0 dB in all factory presets, so
if you need to add gain on your AIR BASE please ad-
just this parameter and store the new setting in a user
preset location.