Reset procedures
Dynaudio Professional AIR reference manual – 2014-09-28 88
Three different Reset “levels” exist. All Reset proce-
dures will affect all monitors connected when they
are executed.
Clear Monitor Settings
The Clear monitor settings reset procedure will reset
all global and local parameters for all connected moni-
tors. Preset and network settings are not affected.
To access this Reset procedure, press and hold the EN-
TER key on the System Controller monitor while pow-
ering it up.
Reset All Settings
The Reset all settings reset procedure is a “factory
reset” that will delete all global and local parameter set-
tings as well as preset and network settings.
To access this Reset procedure, press and hold the EN-
TER key on the System Controller monitor while pow-
ering it up.
Clear Setup for entire network
The Clear setup for entire network reset procedure
will clear settings for your entire AIR system. All con-
nected monitors will be reset to default settings.
To access this Reset procedure, proceed as follows:
►
From the home screen, press the ENTER key.
►
Press the DOWN key until “Setup menu” is dis-
played.
►
Press the ENTER key.
►
Press the DOWN key until “Clear setup for entire
network” is displayed.
►
Press the ENTER key.
“Accept to clear network setup?” is displayed.
►
Press the ENTER key to clear the setup or press
the EXIT key to discard.
To Next Page
Loading...
