5. Operation
Dynaudio Acoustics BM14S 9
Adjusting the volume (Gain)
The correct volume setting is an important aspect in achieving a well balanced
speaker combination.
To adjust the gain:
X Adjust the Gain control, until correct setting is reached.
Selecting the subwoofer cut-off frequency
(Lowpass)
The Lowpass control allows the frequency range of the subwoofer to be defined.
Above the selected frequency the sound level decreases rapidly. The correct setting
of this cut-off frequency is important for a well balanced combination of subwoofer and
speakers.
To select the cut-off frequency
X Set the Lowpass control to the desired frequency between 50 and 150 Hz.
X Please also heed the instructions given in the operating manual of your
loudspeakers.
CAUTION
High Sound Levels!
High sound levels can cause auditory defects.
X To avoid auditory defects do not listen to high sound levels over a longer period
of time.
Note: You cannot adjust the volume, when subwoofer is in slave mode. In this case
the volume is controlled by the setting of the master subwoofer.
Note: • The Lowpass only works on SAT/SUB input.
• Perhaps subwoofer cut-off frequency is already set in the bass
management of your source. Please refer to the operating manual of
your source. In general use only one bass management system.
To Next Page
Loading...
Need help?
General
