P9
Safety InformationPersonal Reference Monitor
Warning!
To reduce the risk of fire or electrical shock, do not
expose this equipment to dripping or splashing
and ensure that no objects filled with liquids, such
as vases, are placed on the equipment.
This apparatus must be earthed.
Use a three wire grounding type line cord like the
one supplied with the product.
Be advised that different operating voltages
require the use of different types of line cord
and attachment plugs.
Always observe the local safety regulations.
Ensure that the factory-set power requirements
for the device (refer to the label on the back of
the monitor) corresponds to the mains supply
in your region.
This equipment should be installed near the
socket outlet and disconnection of the device
should be easily accessible.
To completely disconnect from AC mains, dis-
connect the power supply cord from the AC
receptacle.
The mains plug of the power supply shall remain
readily operable.
Do not install in a confined space.
Do not open the unit – risk of electric shock inside.
Caution:
You are cautioned that any change or modifica-
tions not expressly approved in this manual could
void your authority to operate this equipment
Service:
There are no user-serviceable parts inside.
All service must be performed by qualified per-
sonnel.
EMC/EMI
This equipment has been tested and found to
comply with the limits for a Class B Digital device,
pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in resi-
dential installations. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If the equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off an on, the user is encouraged
to try to correct the interference by one or more
of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV
technician for help.
For customers in Canada:
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
To Next Page
Loading...
Need help?
General
