How to fix a Dynex DX-32L152A11 remote control that is not working?
If the remote control isn't working with your Dynex LCD TV, first, ensure the TV's power cord is plugged in securely. Check for any obstructions between the remote and the TV's remote control sensor. Verify that the batteries are correctly installed in the remote. If problems continue, try replacing the batteries with new ones.
What to do if having trouble programming Dynex LCD TV universal remote?
If you are experiencing issues programming your existing universal remote control with your Dynex LCD TV, see instructions and a table of common codes in the online User Manual. Also, try replacing the batteries. If problems persist, refer to the User Guide that came with your universal remote control and contact the manufacturer.
What to do if my Dynex DX-32L152A11 LCD TV has no picture and no sound?
If your Dynex LCD TV shows no picture and no sound, ensure the power cord is properly plugged in. Then, press the POWER button on either the TV or the remote. Verify that you've selected the correct video input source. If the issue persists, try tuning to another channel, as the broadcasting station might be experiencing technical difficulties.
Why does my Dynex DX-32L152A11 have a picture but no sound?
If your Dynex LCD TV has a good picture but no sound, first, make sure that the sound is not muted. Then, check that the sound mode is set to either Stereo or Mono.
What to do if my Dynex DX-32L152A11 screen shows only snow?
If your Dynex LCD TV displays only snow (noise) on the screen, first try tuning to another channel, as the broadcasting station might be experiencing technical issues. Ensure that the antenna or cable TV is securely and correctly connected. Finally, check the signal strength.
Why is the picture dark on my Dynex LCD TV, but the sound is fine?
If your Dynex LCD TV picture is dark, poor, or nonexistent (but the screen is lit) and the sound is good, try adjusting the brightness settings. Also, make sure that the correct picture mode is selected. Finally, check that the antenna or cable TV connection is both correct and secure.
How to eliminate audio noise on my Dynex DX-32L152A11 LCD TV?
To address audio noise on your Dynex LCD TV, ensure there's no interference from infrared equipment like cordless phones or headphones. If such equipment is present, move it away from the TV to see if the noise is eliminated.
How to adjust color on Dynex LCD TV?
If your Dynex LCD TV has no color, a dark picture, or incorrect colors, try adjusting the color saturation setting.
What to do if control buttons on Dynex LCD TV do not work?
If the control buttons on your Dynex LCD TV are not working, disconnect the power cord, wait a few seconds, then reconnect it and turn the TV back on.
How to reset a lost password on a Dynex LCD TV?
If you've lost the password for your Dynex LCD TV, enter '9999' to access the parental controls. From there, you can set a new password.
General| Display Type | LCD |
|---|---|
| Resolution | 1366 x 768 |
| Aspect Ratio | 16:9 |
| Brightness | 300 cd/m² |
| Response Time | 8 ms |
| HDMI Ports | 2 |
| USB Ports | 1 |
| Refresh Rate | 60Hz |
| Screen Size | 32 in |
| Viewing Angle | 178° horizontal, 178° vertical |
| Inputs | HDMI, USB, VGA, Component, Composite, RF |
To Next Page