How to fix a 'no signal' error message on my Dynex DX-32L200A12 LCD TV?
Press the INPUT button on your Dynex LCD TV remote and ensure you've selected the correct input for the device or service you're trying to use. If you're using a cable or satellite box, use the remote that came with the box to change channels.
How to fix a Dynex DX-32L200A12 LCD TV remote that's not working?
First, ensure the power cord is correctly connected to both your Dynex LCD TV and the power outlet. Then, check for any obstructions between the remote and the TV's remote control sensor. Point the remote directly at the sensor. Make sure the batteries are installed correctly or replace them with new ones.
Why aren't the control buttons working on my Dynex DX-32L200A12 LCD TV?
Make sure that the Button Lock option is set to No on your Dynex LCD TV. If that doesn't work, unplug the power cord, wait a few seconds, then plug the cord back in and turn on your TV.
What to do if control buttons on Dynex LCD TV do not work?
If the control buttons on your Dynex LCD TV do not work, ensure that the Button Lock option is set to NO. If that doesn't work, unplug the power cord, wait a few seconds, then plug it back in and turn on the TV.
How to remove black bars around the picture on my Dynex DX-32L200A12 LCD TV?
Change the aspect ratio setting on your Dynex LCD TV.
Why does my Dynex LCD TV have good picture but no sound?
If your Dynex LCD TV has good picture but no sound, first, increase the volume and make sure the sound isn't muted. Then, check that the correct audio mode is selected and the audio cables are securely connected to the TV's back. Ensure the antenna or cable TV is properly connected. If using an antenna, the digital channel signal may be low. Finally, the audio cables you are using may be bad, so try a new set.
Why does my Dynex LCD TV keep turning off?
If your Dynex LCD TV keeps turning off, make sure that the sleep timer is not turned on.
How to prevent after images on my Dynex DX-32L200A12 LCD TV?
If you are experiencing after images on your Dynex LCD TV, avoid displaying a still image, such as a logo, game, or computer image, for an extended period of time. This can cause a permanent after-image to be burned into the screen, which is not covered by your warranty.
How to fix black bars on my Dynex DX-32L200A12?
To resolve the issue of your Dynex LCD TV picture not filling the screen and having black bars around the picture, change the aspect ratio. An increasing amount of digital TV and movies are presented in wide screen (16:9).
Why is the picture quality poor on some channels of my Dynex LCD TV?
If your Dynex LCD TV picture quality is good on some channels but poor on others, the problem may be a weak signal from the broadcaster or cable TV provider. If you connect to cable or satellite TV without a set-top box, you may need to install a set-top box to improve signal reception and picture quality. Contact your cable or satellite TV provider about upgrading to a set-top box.
General| Screen Size | 32 inches |
|---|---|
| Display Type | LCD |
| Resolution | 1366 x 768 |
| Aspect Ratio | 16:9 |
| HDMI Ports | 2 |
| USB Ports | 1 |
| Display Technology | LCD |
| Brightness | 250 cd/m² |
| Response Time | 8 ms |
| Viewing Angle | 178° (H) / 178° (V) |
| Speakers | 2 x 8W |
| Power Consumption | 65W |
| Inputs | Composite, Component, RF |
To Next Page
